Table of Contents
Advertisement
T10FH
4.5 Mounting the rotor
NOTE
In general, the rotor identification plate is no longer visible after installa
tion. This is why we include with the rotor additional stickers with the
important ratings, which you can attach to the stator or any other rele
vant test−bench components. You can then refer to them whenever there
is anything you wish to know, such as the shunt signal. To explicitly as
sign the data, an identification number is attached on the rotor where it
can be seen from outside (see Fig. 4.5).
1. Prior to installation, clean the measurement flange's and counter flanges'
plane surfaces. For safe torque transfer, the surfaces must be clean and
free from grease. Use a piece of cloth or paper soaked in solvent. When
cleaning, make sure that you do not damage the transmitter coils.
DIN 933 hexagonal screw
Fig. 4.5: Screwed rotor joint
2. For the screwed rotor joint, use DIN 933 hexagonal screws of property
class 12.9 of an appropriate length (depending on the connection geome
try)
A2037−4.0 en
Identification number
DIN 933 hexagonal screw
19
HBM
Advertisement
Table of Contents
