Table of Contents
Advertisement
T10FS
4.3 Installation possibilities
In principle, there are two possibilities for torque flange mounting: with the
antenna ring complete or dismantled. We recommend proceeding as described
in subsection 4.3.1 . If installation in accordance with 4.3.1 is not possible,
(e.g. in the case of subsequent stator replacement or mounting with a speed
measuring system), you will have to dismantle the antenna ring. It is essential
in this case to comply with the notes on assembling the antenna segments
(see "Installing the stator" and Installing the slotted disc").
4.3.1 Installation without undoing the antenna ring (without speed
measuring system)
1. Install rotor
3. Finish installation of shaft run
A0785 14.0 en
2. Install stator
Support supplied by
customer
4. Mount clamp fixture where required.
15
Customer
mounting
Clamp fixture
HBM
Advertisement
Table of Contents
