Table of Contents
Advertisement
14
3.4 Installing the rotor
NOTE
In general, the rotor type-plate will no longer be visible after installation.
Therefore, additional adhesive labels including the major characteristics
have been supplied; they can be fixed on the stator or other relevant
test-rig components thus enabling required data such as e.g. the
calibration signal to be read off at any time.
1. Prior to installation, clean the torque flange's and counter flanges' plan
surfaces. For safe torque transmission, the surfaces must be clean and
free from grease. Use a piece of cloth or paper soaked with a solvant.
Make sure that no solvant drips into the torque flange's interior and that the
transmitter coils do not suffer damage.
Measuring body
Fig. 3.3: Installing the rotor
(Z) 8x DIN912 hexagon
8x fastening screw (10.9, 12.9); observe
maximum length
-
socket screw (10.9/12.9)
T10F
Advertisement
Table of Contents
