Cisco 6800 Series Administration Manual page 57

Phone Installation
Table 9: IPv4 Address Settings Submenu
Field Field Type
or Choices
Connection type DHCP
Static IP
Default Description
Indicates whether the phone has DHCP enabled.
• DNS1—Identifies the primary Domain Name System (DNS)
server that the phone uses.
• DNS2—Identifies the secondary Domain Name System
(DNS) server that the phone uses.
• DHCP address released—Releases the IP address that DHCP
assigned. You can edit this field if DHCP is enabled. To
remove the phone from the VLAN and release the IP address
for reassignment, set this field to Yes and press Set.
When DHCP is disabled, you must set the Internet Protocol (IP)
address of the phone.
• Static IP address—Identifies the IP that you assign to the
phone. The phone uses this IP address instead of acquiring
an IP from the DHCP server on the network.
• Subnet Mask—Identifies the subnet mask used by the phone.
When DHCP is disabled, you must set the subnet mask.
• Gateway address—Identifies the default router used by the
phone.
• DNS1—Identifies the primary Domain Name System (DNS)
server that the phone uses. When DHCP is disabled, you
must set this field manually.
• DNS2—Identifies the primary Domain Name System (DNS)
server that the phone uses. When DHCP is disabled, you
must set this field manually.
When you assign an IP address using this field, you must also
assign a subnet mask and a gateway address. See the Subnet Mask
and Default Router fields in this table.
Cisco IP Phone 6800 Series Multiplatform Phones Administration Guide
Network Configuration Fields
43