Cisco 6800 Series Administration Manual page 237

Phone Troubleshooting
Parameter
Admin Password
User Password
Phone-UI-readonly
Phone-UI-User-Mode
Block Nonproxy SIP
Network Settings
Parameter
IP Mode
Description
Allows you to enter password for the administrator.
Default: Blank
Allows you to enter password for the user.
Default: Blank
Allows you to make the phone menus and options that
the phone users see as read-only fields.
Default: No
Allows you to restrict the menus and options that
phone users see when they use the phone interface.
Choose yes to enable this parameter and restrict
access.
Default: No
Specific parameters are then designated as "na", "ro",
or "rw" using provisioning files. Parameters
designated as "na" don't appear on the phone screen.
Parameters designated as "ro" aren't editable by the
user. Parameters designated as "rw" are editable by
the user.
Enables or disables the phone receiving SIP messages
from non-proxy server. If you choose Yes, the phone
blocks any incoming non-proxy SIP messages except
IN-dialog message. If you choose No, the phone does
not block any incoming non-proxy SIP messages.
Set Block Nonproxy SIP to No for phones that use
TCP or TLS to transport SIP messages. Nonproxy
SIP messages transported over TCP or TLS are
blocked by default.
Default: No
Description
Allows you to select the internet protocol mode in
which the phone operates. Options are: IPv4 Only,
IPv6 Only, and Dual Mode. In dual mode, the phone
can have both IPv4 and IPv6 addresses.
Default: Dual Mode
Cisco IP Phone 6800 Series Multiplatform Phones Administration Guide
Network Settings
223