Cisco 6800 Series Administration Manual page 55

Phone Installation
Field Field Type
or Choices
LLDP-MED On
Off
Startup delay
VLAN On
Off
VLAN ID
PC port VLAN ID
PC port mirror On
Off
Default Description
On Enable or disable LLDP-MED.
LLDP-MED enables the phone to advertise itself to devices that
use the discovery protocol.
3 seconds Set a value that causes a delay for the switch to get to the
forwarding state before the phone sends out the first LLDP-MED
packet. For configuration of some switches, you might need to
increase this value to a higher value for LLDP-MED to work.
Configuring a delay can be important for networks that use the
Spanning Tree Protocol.
Default delay is 3 seconds.
Off Enable or disable VLAN.
Permits you to enter a VLAN ID when you use VLAN without
CDP or LLDP. When you use a VLAN with CDP or LLDP, that
associated VLAN takes precedent over the VLAN ID you
manually entered.
1 Enter a VLAN ID for the IP phone when you use a VLAN without
CDP (VLAN enabled and CDP disabled). Note that only voice
packets are tagged with the VLAN ID. Do not use the 1 value for
the VLAN ID. If VLAN ID is 1, you cannot tag voice packets
with the VLAN ID.
1 Enter a value of the VLAN ID that is used to tag communications
from the PC port on the phone.
The phone tags all the untagged frames coming from the PC (it
does not tag any frames with an existing tag).
Valid values: 0 through 4095
Default: 0
Off Adds the ability to port mirror on the PC port. When enabled, you
can see the packets on the phone. Select On to enable PC port
mirroring and select Off to disable it.
Cisco IP Phone 6800 Series Multiplatform Phones Administration Guide
Network Configuration Fields
41