Cisco 6800 Series Administration Manual page 268

Distinctive Ring Patterns
Parameter
Call Waiting Tone
Confirm Tone
MWI Dial Tone
Cfwd Dial Tone
Holding Tone
Conference Tone
Secure Call Indication Tone
Page Tone
Alert Tone
Mute Tone
Unmute Tone
System Beep
Call Pickup Tone
Distinctive Ring Patterns
Parameter
Cadence 1
Cadence 2
Cadence 3
Cisco IP Phone 6800 Series Multiplatform Phones Administration Guide
254
Description
Played when a call is waiting.
Brief tone to notify the user that the last input value
has been accepted.
Played instead of the Dial Tone when there are
unheard messages in the caller's mailbox.
Played when all calls are forwarded.
Informs the local caller that the far end has placed the
call on hold.
Played to all parties when a three-way conference call
is in progress.
Played when a call has been successfully switched
tosecure mode. It should be played only for a short
while (less than 30 seconds) and at a reduced level
(less than -19 dBm) so it does not interfere with the
conversation.
Specifies the tone transmitted when the paging feature
is enabled.
Played when an alert occurs.
Played when the Mute button is pressed to mute the
phone.
Played when the Mute button is pressed to unmute
the phone.
Audible notification tone played when a system error
occurs.
Provides the ability to configure an audio indication
for call pickup.
Description
Cadence script for distinctive ring 1.
Defaults to 60(2/4).
Cadence script for distinctive ring 2.
Defaults to 60(.3/.2, 1/.2,.3/4).
Cadence script for distinctive ring 3.
Defaults to 60(.8/.4,.8/4).
Phone Troubleshooting