Parameter Group 12-** Ethernet - Danfoss EtherNet/IP Midi Drive FC 280 Programming Manual

Parameters
5.1.6 8-7* Protocol SW Version
8-79 Protocol Firmware version
Range: Function:
Size related [0 - 65535 ] Firmware revision: FC is in index 0;
*
Modbus is in index 1; indexes 2–4
are reserved.
5.1.7 8-8* FC Port Diagnostics
These parameters are used for monitoring the bus
communication via the frequency converter port.
8-80 Bus Message Count
Range: Function:
0 [0 - 4294967295] This parameter shows the number of valid
*
telegrams detected on the bus.
8-81 Bus Error Count
Range: Function:
0 [0 - 4294967295] This parameter shows the number of
*
telegrams with faults (for example CRC
faults) detected on the bus.
8-82 Slave Messages Rcvd
Range: Function:
0 [0 - 4294967295] This parameter shows the number of valid
*
telegrams sent by the frequency converter
to the slave.
8-83 Slave Error Count
Range: Function:
0 [0 - 4294967295] This parameter shows the number of error
*
telegrams, which could not be executed
by the frequency converter.
8-84 Slave Messages Sent
Range: Function:
0 [0 - 4294967295] This parameter shows the number of
*
messages sent from the slave.
8-85 Slave Timeout Errors
Range: Function:
0 [0 - 4294967295] This parameter shows the number of slave
*
timeout errors.
8-88 Reset FC port Diagnostics
Option: Function:
[0] Do not reset Do not reset all FC port diagnostic counters.
*
[1] Reset counter Reset all FC port diagnostic counters.
MG07H102
Programming Guide
5.1.8 8-9* Bus Feedback
Use the parameter group to configure the bus feedback.
8-90 Bus Jog 1 Speed
Range:
100 RPM
8-91 Bus Jog 2 Speed
Range:
200 RPM

5.2 Parameter Group 12-** Ethernet

5.2.1 12-0* IP Settings
12-00 IP Address Assignment
Option:
[0] MANUAL
[1] DHCP
[2] BOOTP
[10] DCP
*
[20] From node
ID
12-01 IP Address
Range:
0 [0 -
*
4294967295]
12-02 Subnet Mask
Range:
0 [0 -
*
4294967295]
Danfoss A/S © 06/2016 All rights reserved.
Function:
[ 0 - 1500 Enter the jog speed. Activate this
*
RPM] fixed jog speed via the serial port or
fieldbus option.
Function:
[ 0 - 1500 Enter the jog speed. Activate this
*
RPM] fixed jog speed via the serial port or
fieldbus option.
Function:
Select the IP address assignment method.
IP address can be set in parameter 12-01 IP
Address IP Address.
IP address is assigned via DHCP server.
IP address is assigned via BOOTP server.
DCP is assigned via the DCP protocol.
Function:
Configure the IP address of the option.
Read-only, if parameter 12-00 IP Address
Assignment is set to DHCP or BOOTP. In
POWERLINK, the IP address follows the
parameter 12-60 Node ID last byte and the
first part is fixed to 192.168.100 (node ID).
Function:
Configure the IP subnet mask of the
option. Read-only, if parameter 12-00 IP
Address Assignment is set to DHCP or
BOOTP. In POWERLINK, it is fixed to
255.255.255.0.
5 5
25