Parameter Setup; Introduction To Parameter Setup; Digital In/Out; Parameter Group 5-1* Digital Inputs - Danfoss VLT MCB 113 Operating Manual

Operating Guide | VLT® Extended Relay Card MCB 113

4 Parameter Setup

4.1 Introduction to Parameter Setup

The parameters included in this Operating Guide are extracts from the drive-specific programming guides. Refer to these
Programming Guides for full parameter descriptions.

4.2 5-** Digital In/Out

4.2.1 Parameter Group 5-1* Digital Inputs

The digital inputs are used for selecting various functions in the drive. Refer to
inputs.
Functions in group 1 have higher priority than the functions in group 2.
Group 1 Reset, coast stop, reset, and coast stop, quick stop, DC brake, stop, and the [Off] key.
Group 2 Start, latched start, reversing, start reversing, jog, and freeze output.
Table 7: Digital Input Functions
Digital input function
No operation
Reset
Coast inverse
Coast and reset inverse
Quick stop inverse
DC brake inverse
Stop inverse
Start
Latched start
Reversing
Start reversing
Enable start forward
Enable start reverse
Jog
Preset reference on
Preset ref bit 0
Preset ref bit 1
Preset ref bit 2
Freeze reference
Freeze output
Danfoss A/S © 2020.01
table 7 to see which functions can be assigned to digital
Select Terminal
[0] All, terminal 32, 33
[1] All
[2] All, terminal 27
[3] All
[4] All
[5] All
[6] All
[8] All, terminal 18
[9] All
[10] All, terminal 19
[11] All
[12] All
[13] All
[14] All, terminal 29
[15] All
[16] All
[17] All
[18] All
[19] All
[20] All
AQ322553864968en-000101 / 130R0353| 15
Parameter Setup