Danfoss EtherNet/IP Midi Drive FC 280 Programming Manual page 40

Appendix
Attribute
1
2
3
4
5
6
7
8
9
7 7 Table 7.3 Instance Attributes-Class ID 0x06 Connection Manager
Attribute
1
2
3
6
7
8
9
12
15
Table 7.4 Instance Attributes-Class ID 0x28 Motor Data Object
NOTICE
Class ID 0x28 is only available when ODVA profile is selected in parameter 8-10 Control Word Profile.
Attribute
1
2
3
4
5
6
7
8
9
10
11
12
38
EtherNet/IP
Access Name
Get Open requests
Get Open format rejects
Get Open resource rejects
Get Open other rejects
Get Close requests
Get Close format requests
Get Close other requests
Get Connection timeouts
Connection entry list struct of
Get
NumConnEntries
Access Name
Number of attributes
Get
supported
Get List of attributes supported
Get/Set Motor type
Get/Set Rated current
Get/Set Rated voltage
Get/Set Rated power
Get/Set Rated frequency
Get/Set Pole count
Get/Set Base speed
Access Name
Get Number of attributes supported
Get List of supported attributes
Get/Set Run 1 (forward)
Get/Set Run 2 (reverse)
Get/Set Network control
Get State
Get Running 1
Get Running 2
Get Ready
Get Faulted
Get Warning
Get/Set Fault reset
Danfoss A/S © 06/2016 All rights reserved.
Data type
Uint Number of forward open requests received.
Number of forward open requests rejected due to bad
Uint
format.
Number of forward open requests rejected due to lack of
Uint
resources.
Number of forward open requests rejected due to other
Uint
reasons.
Uint Number of forward close requests received.
Number of forward close requests rejected due to bad
Uint
format.
Number of forward close requests rejected due to other
Uint
reasons.
Uint Number of connection timeouts.
Number of connection entries ConnOpenBits ARRAY of BOOL
INT
List of connection data.
Data type Parameter
USINT –
Array of USINT –
USINT 1-10
Uint 1-24
Uint 1-22
UDINT 1-20
Uint 1-23
Uint 1-39
Uint 1-25
Data type
USINT 12
Array of USINT 3,4,4,5,6,7,8,9,10,11,12,13,15
Frequency converter CTW bit 6=Run 1 XOR Run 2
Boolean
Frequency converter CTW bit 15 = 0.
Frequency converter CTW bit 6 = Run 1 XOR Run
Boolean 2
Frequency converter CTW bit 15 = 1.
Parameter 12-32 Net Control value written from
Boolean
option.
USINT The state of the CIP state-machine.
Boolean Run 1 AND bit 11 in frequency converter STW
Boolean Run 2 AND bit 11 in frequency converter STW.
STATE_ENABLED or STATE_STOPPING or
Boolean
STATE_FAULT_STOP from state-machine.
Boolean Bit 3 in frequency converter STW.
Boolean Bit 7 in frequency converter STW.
Boolean Bit 7 in frequency converter CTW.
Description
Description
7
3,6,7,8,9,12,15
3: PM sync. motor ( only)
7: Squirrel cage induction motor
Unit: 100 mA
Unit: Volt
Unit: Watt
Unit: Hertz
Number of poles in motor
Unit: RPM
Description
MG07H102