Danfoss EtherNet/IP Midi Drive FC 280 Programming Manual page 28

Parameters
12-03 Default Gateway
Range:
0 [0 -
*
4294967295]
12-04 DHCP Server
Range:
5 5
0 [0 - 2147483647 ] Read-only. Show the IP address of the
*
12-05 Lease Expires
Range:
0 [0 - 4294967295] Read-only. Show the lease time left for
*
12-06 Name Servers
Range:
0 [0 - 4294967295] IP addresses of domain name servers. Can
*
12-07 Domain Name
Range:
0 [1 - 48] Domain name of the attached network. Can be
automatically assigned when using DHCP network.
12-08 Host Name
Range:
0 [0 - 48 ] Logical (given) name of option.
*
12-09 Physical Address
Range:
0 [0 - 17] Read-only. Show the physical (MAC) address of the
*
26
Function:
Configure the IP default gateway of the
option. Read-only, if parameter 12-00 IP
Address Assignment is set to DHCP or
BOOTP. In a non-routed network, this
address is set to the IP address of the IO
Device.
Function:
found DHCP or BOOTP server.
Function:
the current DHCP-assigned IP address.
Function:
be automatically assigned when using
DHCP.
Function:
Function:
NOTICE
The display of the frequency converter only
shows the first 19 characters, but the
remaining characters are stored in the
frequency converter. If hardware switches
are different from all ON or all OFF, the
switches have priority.
Function:
option.
Danfoss A/S © 06/2016 All rights reserved.
EtherNet/IP
5.2.2 12-1* Ethernet Link Parameters
Apply to the whole parameter group.
Index [0] is used for port 1, and index [1] is used for port
2.
12-10 Link Status
Option:
[0] No Link
*
[1] Link
12-11 Link Duration
Range:
Size related
12-12 Auto Negotiation
Option: Function:
[0] Off Link Speed and Link Duplex can be configured in
[1] On
*
12-13 Link Speed
Option:
[0] None
*
[1] 10 Mbps
[2] 100
Mbps
NOTICE
In POWERLINK, this parameter is locked to 100 Mbs.
12-14 Link Duplex
Option:
[0] Half Duplex
[1] Full Duplex
Function:
Read-only. Show the link status of the Ethernet
ports.
Function:
[ 0 - 0] Read-only. Show the duration of the
*
present link on each port in dd:hh:mm:ss.
Configure auto negotiation of Ethernet link
parameters, for each port: ON or OFF.
parameter 12-13 Link Speed and parameter 12-14 Link
Duplex.
Function:
Force the link speed for each port in 10 Mbps or
100 Mbps. If parameter 12-12 Auto Negotiation is
set to [1] On, this parameter is read-only and
shows the actual link speed. If no link is present,
None is shown.
Function:
NOTICE
In POWERLINK, this parameter is locked
to half duplex.
Force the duplex for each port to full or half
duplex. If parameter 12-12 Auto Negotiation is
set to [1] On, this parameter is read-only.
MG07H102