Table of Contents
Advertisement
5:
Route the wires under the black bridge restraints at the new locations.
6:
Insert the red and black wires into their new location. Tighten the wire-retaining screws. Gently
pull on the wires to verify that they are properly connected.
Data In
7:
Repeat steps 5 and 6 for all remaining connections.
8:
Replace the coupler cover and secure in place.
62
Figure 2: New wire connection
DataTrack/DataTrack Backbone System Planning and Installation Manual
New Wire Connection
Data Out
Advertisement
Table of Contents
Need help?
Do you have a question about the DataTrack and is the answer not in the manual?
Questions and answers