Installing Mid Feeds - ETC DataTrack Planning And Installation Manual

Installing Mid Feeds

Note:
If you are using DataTrack Backbone, see the installation instructions provided with the DataTrack
Backbone mid feed housing to install the housing on the mid feed. See
1: Install the mid feed in any position on a surface-mounted track. Remove burrs.
2: Mount the mid feed canopy.
a
c
Installation
Due to concerns about DMX performance, ETC recommends that you use mid feeds
to provide power to the track, not DMX.
Drill hole on top of track
where you want to put the
adapter to pass through wires
Figure 8: Install the mid feed
b
Figure 9: Mount the mid feed canopy
0.55 in
0.59 in (14 mm)
0.31 in
(15 mm)
(7.9 mm)
Slide the canopy so that the bracket cutout covers
d
around the 0.59 in (15 mm) drilled hole.
Mid Feed Housing page 49
on .
19