Programming Procedure - NEC NEAX 2000 IPS Maintenance Manual

Programming Procedure

The following explains the procedures for command operation from CAT/MAT.
• CME4 Y=00 (Readout service setting status for each station A)
E400
X~XXXXXXXX
(Station Number)
• CME4 Y=01 (Readout service setting status for each station B)
E401
X~XXXXXXXX
(Station Number)
ST COMMAND=
+ DE E400>
+ DE X~XXXXXXXX : a b c d e f g h
ST COMMAND=
+ DE E401>
+ DE X~XXXXXXXX : i j k l m n o p
CHAPTER 1 MAINTENANCE SERVICE FEATURES
Station Number
a : Terminal connection status
b : Make Busy
c : Line status
d : Call Forwarding-All Calls
e : Call Forwarding-Busy Line
f : Call Forwarding-Don't Answer (No Answer)
g : Logout/Call Forwarding-PS out of cell (zone)
h : Do Not Disturb
For details of abcdefgh, refer to Table A
(Readout Service Setting Status for Each Station A).
Page 106
Station Number
i : Mobility access (Station Access/Call Forwarding)
j : Day/Night mode change
k : Number Sharing
l : Split Call Forwarding-All Calls
m : Split Call Forwarding-Busy Line/Don't Answer (No Answer)
n : ACD/UCD Busy Out (UCDB)
o : Outgoing Call Restriction
p : Not used
For details of abcdefgh, refer to Table B
(Readout Service Setting Status for Each Station B).
Page 107
– 105 –
STATION SERVICE STATUS DISPLAY
NWA-008847-001 Rev.3.0
a6ch1001.fm
JULY/01/2006