Service Conditions - NEC NEAX 2000 IPS Maintenance Manual

Service Conditions

(1) General conditions
• Terminals/cards and available firmware versions that enable to collect fault logs/call logs are as
follows.
Terminals/Cards
term
Terminals D 85 (Series i) (IP Adapter Type)
term
D 85 (Series i) (IP Bundled Type)
term
D IP INASET (ITR-240G-1)
term
D SP30
IP-CS
term
D 75 (Series E) (IP Adapter Type)
term
D IP INASET (ITR-LC-1)
term
D SP20
Cards PN-8IPLA (IP-PAD)
PN-32IPLA/PN-32IPLA-A (IP-PAD)
PN-8IPTA (SIP)
PN-IPTB (IPT)
NOTE: Fault information store/display is not available for the following D
Type). But it will be available when the new firmware is installed.
- ITR-8D-2 (BK/WH) TEL (Available when firmware of ITR-8D-3 (BK/WH) TEL is installed)
- ITR-16D-2 (BK/WH) TEL (Available when firmware of ITR-16D-3 (BK/WH) TEL is installed)
- ITR-8D-2A (BK/WH) TEL (Available when firmware of ITR-8D-3A (BK/WH) TEL is installed)
- ITR-16D-2A (BK/WH) TEL (Available when firmware of ITR-16D-3A (BK/WH) TEL is in-
stalled)
- ITR-8D-2U (BK/WH) TEL (Available when firmware of ITR-8D-3 (BK/WH) TEL is installed)
- ITR-16D-2U (BK/WH) TEL (Available when firmware of ITR-16D-3 (BK/WH) TEL is in-
stalled)
• Collected fault logs and call logs can be output to a PC via the RS port (RS-232C) of the MP card.
To output the fault logs and call logs, communication software (Hyper Terminal, etc.) must be in-
stalled in the PC (MATWorX cannot be used while using the communication software).
CHAPTER 1 MAINTENANCE SERVICE FEATURES
Available: ×
Not available: -
Fault Log
Collection
×
×
NOTE
×
×
×
-
-
-
×
-
-
-
– 88 –
VoIP LOG COLLECTION
Firmware Version
Call Log
Collection
Ver. 2.80 or later
×
Ver. 2.80 or later
×
E0 2.80 or later
×
F Ver. 7.3.0.0 or later
×
SC-3375 8A or later
×
-
-
-
SC-3386 IPS IPADT
×
PROG-C1 or later
-
SC-3591 IPS IPATT
×
PROG-B1 or later
-
term
85 (Series i) (IP Bundled
NWA-008847-001 Rev.3.0
a6ch1001.fm
JULY/01/2006