INSTALLATION PROCEDURE
Install the Remote PIM System according to the following procedure.
Installation Procedure for Main Site
Figure 2-2
shows a flowchart of the installation procedure for the Main Site.
NOTE 1: This procedure is required even if the Main Site is 1-PIM/2-PIM configuration.
NOTE 2: This procedure is required when providing PN-M10 card to connect an optical
interface.
2
NEAX2000 IVS
Remote PIM System Manual
ND-70917 (E), Issue 1.0
Figure 2-2 Installation Procedure for Main Site
Mounting DAIA Card for T1 /
Mounting DAIC Card for T1 /
Mounting FP Card
Mounting M10 Card
BUS Cable Connection
DAI Connection at Main Site
Optical Cable Connection
START
DAID Card for E1
DAIF Card for E1
NOTE 1
NOTE 2
MP Reset
END
CHAPTER 2 INSTALLATION
Installation Procedure
See
Page
23.
See
Page
23.
See
Page
23.
See
Page
23.
See
Page
24.
See
Page
47.
See
Page
51.
See
Page
55.
Page 21