Online Mp-Fp Command Output; General Description; Service Conditions - NEC NEAX 2000 IPS Maintenance Manual

ONLINE MP-FP COMMAND OUTPUT

[Series 3700 R12.2 software required]

General Description

This feature enables to store an MP-FP command and output RS in online mode. By this feature, you can
analyze a cause of failure without difficulty even during operation.

Service Conditions

(1) 64 K bytes of command data can be stored in the MP card.
(2) Stored command data backup is not executed automatically. When initializing the system, the stored
command data will be erased.
(3) The stored command data can be output via RS-232C or built-in modem.
(4) When "Output only when Nth byte of command is certain data (CMF6 Y=2>30, 31, 32, 33)" is set,
only commands that match the conditions are stored during storing command data storage.
(5) When Status Output (CMF6 Y=2>40) is set, data of station status (trunk status) is added to all IN
commands (commands that receive information from FP/AP to MP) /OUT commands (commands
that send information from MP to FP/AP) and stored on buffer memory and output.
(6) When station line status display (CMF6 Y=2>40) is set, output information is the following.
STATION/TRUNK SET BY STATUS
Single line telephone
term term
D /D IP
Virtual station (CM11)
PS virtual station (CM14)
PS station No. (CM14)
Trunk
OUTPUT
CHAPTER 1 MAINTENANCE SERVICE FEATURES
OUTPUT INFORMATION
Station No., status of the station
Station No., status of the station (status of the
virtual station)
Virtual station No., status of the virtual station
Virtual station No., status of the PS virtual sta-
tion
PS station No., status of the PS station, call sta-
tus of the PS station
Trunk No., status of the trunk
– 80 –

ONLINE MP-FP COMMAND OUTPUT

NWA-008847-001 Rev.3.0
a6ch1001.fm
JULY/01/2006