NEC NEAX 2000 IPS Maintenance Manual page 211

CARD NAME
PN-32IPLA/ RUN lamp is not
PN-32IPLA-A flashing
(IP-PAD)
PN-32IPLA/ LINK lamp is not
PN-32IPLA-A on
(IP-PAD)
[PZ-M571/
PZ-M632]
Remedial Action on Each Lamp Status
LAMP FAULT
STATUS CONTENT
Abnormal opera-
tion of IP-PAD
card
LAN connection
failure
CHAPTER 2 TROUBLESHOOTING
FAULT DIAGNOSIS AND TROUBLESHOOTING
REMEDIAL ACTION
Confirm whether the MODE switch
1
is set to 0, 3, or 4.
0: Auto Negotiation ON
(Recommended)
3: Auto Negotiation OFF
(10 Mbps fixed)
4: Auto Negotiation OFF
(100 Mbps fixed)
Confirm the programming data:
2
CM0A.
Reset the MB switch.
3
(Down Up Down)
If the fault cannot be cleared,
4
replace the card.
Check to see if the LAN cable is
1
correctly connected.
Confirm the condition of the LAN
2
device (such as power of the HUB)
connected to the IP-PAD.
Confirm whether the MODE switch
3
is set to 0.
If the fault cannot be cleared,
4
replace the card.
– 201 –
Continued on next page
NWA-008847-001 Rev.3.0
a6ch2001.fm
OCTOBER/14/2005