Installation Overview - Extron electronics TouchLink TLI Pro 101 User Manual

Interface
Hide thumbs Also See for TouchLink TLI Pro 101:
Table of Contents

Advertisement

Installation
Overview
1.
2.
3.
4.
5.
Before starting, download and install the latest versions of the following software:
Global Configurator Professional and Global Configurator Plus — for setting up and
configuring the control processor, interface, and third-party touchpanel.
GUI Designer — for designing layouts for Extron TouchLink Pro interfaces and
third-party touch interfaces.
See
Configuration Software
Obtain the following network information from your network administrator:
DHCP setting (On or Off). If the DHCP setting is Off, you also need:
TLI Pro 101 IP address
Subnet mask
Gateway IP address
User name — by default these are either
Passwords — by default these are either
(for user).
MAC address — make a note of the TLI Pro 101 MAC address.
Mount the units. Stand the TLI Pro 101 on a convenient surface, mount it in a standard
rack, or use an under-table mounting kit (see
third-party touchpanel follow the instructions provided by the manufacturer.
Connect cables to the TLI Pro 101 (see
Connections
on page 5).
Connect the HDMI output from the TLI Pro 101
party touchpanel.
Connect the USB port from the TLI Pro 101
touchpanel.
NOTE: The USB connection passes information to the TLI Pro 101 about where on
the screen the touchpanel was pressed. To use a normal monitor instead of a
touchscreen, connect a mouse to the TLI Pro 101 USB connection. Use the mouse
to click on screen icons.
Connect the power cords and power on all devices (see
and Power over Ethernet (PoE) Connector
ATTENTION:
Do not power on the interfaces or control processors until you have read the
Attention notice on
injector).
Ne branchez pas les interfaces ou les contrôleurs avant d'avoir lu les mises
en garde
page 7
(source d'alimentation 12 VCC) ou
PoE).
on page 23.
or
admin
user
(for admin) or the field is left blank
extron
Mounting
on page 26). To mount the
TLI Pro 101 Rear Panel Features and
(figure
2,
(figure
Power
on page 10).
page 7
(12 VDC power supply) or on
TLI Pro 101 • Installation Overview
.
2,
C
on page 5) to the third-
D
) to the third-party
Network
on page 6 or
page 11
(power
page 11
(injecteur
3

Advertisement

Table of Contents
loading

Table of Contents