Installation Overview - Extron electronics TLP Pro 1022M User Manual

Installation
Overview
1.
2.
3.
4.
5.
6.
Before starting, download and install the latest versions of the following software:
GUI Designer — for designing layouts for Extron TouchLink Pro touchpanels and third
…
party touch interfaces.
Global Configurator Plus and Professional — for setting up and configuring the
…
control processor and touchpanel.
Toolbelt — provides device discovery, device information, firmware updates,
…
and configuration of network settings, system utilities, and user management for
TouchLink Pro devices.
Configuration Software
See
Obtain the following network information from your network administrator:
DHCP status ( On or Off
…
IP address
…
Subnet mask
…
Gateway
…
User name — this can be either admin or user.
…
Password — by default this is
…
MAC address — make a note of the touchpanel MAC address.
…
Connect cables to the units:
ATTENTION:
Do not power on the touchpanels or control processors until you have read the
•
Attention notice on
Ne branchez pas les écrans tactiles ou les contrôleurs avant d'avoir lu les mises
•
en garde page 6.
Connect cables to the touchpanels (see
…
Connect the power cords and power on all devices (see
…
page 5).
Set up the Touchpanels for Network Communication:
Connect the PC that you are using for setup, the Extron control processor, and the
…
touchpanel to the same Ethernet subnetwork.
Use the Setup Menu (see page 8) or Toolbelt to set the DHCP status and, if required,
…
the IP address, subnet mask, gateway, and related settings for the touchpanel.
Mount the units. There are several mounting options for either touchpanel (see
page 18).
NOTE:
If you use the setup menu to configure the TLP Pro 1022M, do not mount the
unit before configuring it. You need access to the rear panel
Configure the Touchpanels — the GUI Designer Help File, the Global Configurator Help File,
and the Toolbelt Help File, provide step-by-step instructions and detailed information.
The Global Configurator Help File also includes an introduction to that software and sections
on how to start a project and configuration.
on page 14.
). If DHCP is off, you also require
(for either
extron admin
page 6.
Rear Panel Features
TLP Pro 1022 Series • Installation Overview
or ).
user
on page 5).
LAN/PoE Connector on
Mounting
button.
Menu
on
3