Table of Contents
Advertisement
Reset mode LED (see
F
status when the reset button is pressed (see
Reset button (recessed) (see
G
any of three different modes (see
TLI Pro 101 Front Panel Features
A
Figure 5.
A
Power LED — Lights when the unit is powered on.
Menu button (recessed) — Opens the
B
calibration screen
Press the button briefly (less than 2 seconds) to open the setup menu screens.
z
Press and hold the button (at least 3 seconds) to open the calibration screen. Follow
z
the on-screen instructions to calibrate the touchpanel.
Press the button briefly (less than 2 seconds) for a second time to close the current
z
screen without saving any changes.
C
100 Mb network LED — Lights when the unit is connected to a 100 Mb network.
Network link LED — Lights when the unit is connected to a network.
D
Network activity LED — Flashes when there is activity on the network connection.
E
figure 2
on page 5) — Provides feedback about the reset
F
figure 2
Reset Modes
TLI Pro 101 Plus Front Panel
(see page 22) for the interface:
Reset Modes
on page 27).
G
on page 5) — Allows the unit to be reset in
on page 27).
MENU
B
setup menu
(see the following page) and
TLI Pro 101 • Panel Features
TLI PRO 101
TOUCHLINK INTERFACE
C
100
LINK
ACT
E D
12
Advertisement
Chapters
Table of Contents
