Installation Overview - Extron electronics TLP Pro 525 Series User Manual

Table of Contents

Advertisement

Installation
Overview
This section provides an overview of the installation process. Follow the links for a more detailed
explanation of each step.
1.
2.
Before starting to install the TLP Pro models, download and install the latest versions of the
following software:
GUI Designer — For designing layouts for Extron TouchLink Pro touchpanels and third
party touch interfaces.
Global Configurator Plus and Professional — For setting up and configuring the
control processor and touchpanel.
Toolbelt — Provides device discovery, device information, firmware updates,
and configuration of network settings, system utilities, and user management for
TouchLink Pro devices.
Global Scripter —
Provides an integrated development environment for Extron control
systems programming.
See
Configuration Software
NOTE:
The TLS models do not need to be configured or programmed. Other than
setting network addresses (see
as shipped.
Before starting to install the TLP Pro models, obtain the following network information from
your network administrator:
Dynamic Host Configuration Protocol (DHCP) status (on or off). If DHCP is off, you
also require:
IP address
User name — This can be either admin or user.
Password — The factory configured passwords for all accounts on this device have
been set to the device serial number. Passwords can be changed during configuration.
Passwords are case sensitive.
NOTE: If the device is reset to default settings, the password is the default
password configuration. The default password is
accounts).
user
MAC address — Make a note of the touchpanel MAC address, which can be found
on the rear panel label (TLP Pro 525M, 725M, or 1025M) or a label on the base
(TLP Pro 525T, 725T, or 1025T).
NOTE:
This information is not required for the TLS models.
SSL security certificates and IEEE 802.1X authentication — Extron touchpanels
come with a factory‑installed Secure Sockets Layer (SSL) security certificate. IEEE
802.1X authentication is also supported once enabled. See
(SSL) Certificates
on page 35 or see
more information.
TLP Pro 525, 725, and 1025 Series Touchpanels • Installation Overview
on page 21.
Setup Menu
on page 14), they are ready to use,
Subnet mask
extron
IEEE 802.1X Certificates
Gateway
(for either
or
admin
Secure Sockets Layer
on page 36 for
4

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tlp pro 725 seriesTlp pro 1025 seriesTouchlink tlp pro 525 seriesTouchlink tlp pro 725 seriesTouchlink tlp pro 1025 seriesTls 525m ... Show all

Table of Contents