Reference Material; Reset Modes; Use Factory Firmware - Extron electronics TouchLink TLI Pro 101 User Manual

Reference
Material
This section describes:
z
z

Reset Modes

The TLI Pro 101 has three reset modes that are initiated by pressing the Reset button:
z
z
z
The Reset button is found on the rear panel (see

Use Factory Firmware

Activation
To start the
1.
2.
Result
The unit continues to run factory-installed firmware until you update the firmware or power
is cycled to the unit, which then reboots with the last loaded version of the firmware. The
TLI Pro 101 reverts to the factory default firmware. Event scripting does not start if the unit
is powered on in this mode. All user files and settings such as drivers, adjustments, and
IP settings are maintained.
NOTE:
Reset Modes
Licensed Third-Party Software Used in the Interface
Use Factory Firmware
Reset All IP Settings
Reset to Factory Defaults
Use Factory Firmware
On the TLI Pro 101, hold down the recessed
unit. Hold the button down until the Power LED blinks twice. The interface enters factory
firmware mode, and the LED flashes quickly.
Upload new firmware to the unit as desired (see
NOTE: After a User Factory Firmware reset is performed, update the IPL Pro control
processor firmware to the latest version. Do not operate the interface firmware
version that results from the reset. This mode temporarily resets the unit to factory
default until power is recycled. If you want to use the factory default firmware, you
must upload that version again (see
To return the unit to the firmware version that was running prior to the reset, cycle
power to the unit.
figure 2, on page 5).
G
reset mode and replace firmware:
Reset button while applying power to the
Updating the Firmware
Updating the Firmware
TLI Pro 101 • Reference Material
on page 25).
on page 25).
27