Reset All Ip Settings; Reset To Factory Defaults - Extron electronics TouchLink TLI Pro 101 User Manual

Purpose and Notes
Use this mode to temporarily boot up the unit with factory installed firmware for a single power
cycle in the event that a firmware update has failed or if incompatibility issues arise with user-
loaded firmware.
NOTE:
firmware version.

Reset All IP Settings

Activation
To reset all IP settings:
1.
Hold down the
at 3 seconds and again at 6 seconds).
2.
Release and press
if the momentary press does not occur within 1 second.
Result
Reset All IP Settings
Sets the IP address back to factory default (192.168.254.251).
z
Sets the subnet back to factory default (255.255.255.0).
z
Sets the default gateway address to the factory default (0.0.0.0).
z
Turns DHCP off.
z
Purpose and Notes
Reset All IP Settings
defaults.

Reset to Factory Defaults

Activation
To reset the unit to all factory default settings:
1.
Hold down the
(once at 3 seconds, again at 6 seconds, and again at 9 seconds).
2. Release and press
if the momentary press does not occur within 1 second.
Result
Reset to Factory Defaults
the firmware).
Does everything
z
Clears driver-port associations (serial and Ethernet) and port configurations.
z
Removes button and touchpanel configurations.
z
Resets all IP options.
z
Removes schedules, settings and macros.
z
Removes or clears all user-loaded files and configurations from the control processor.
z
Purpose and Notes
Reset to Factory Defaults
uploading.
User-defined web pages may not work correctly if you are using an earlier
Reset button for about 6 seconds until the Power LED blinks twice (once
Reset momentarily (for <1 second) within 1 second. Nothing happens
mode:
mode enables you to reset IP settings and port maps to factory
Reset button for about 9 seconds until the Power LED blinks three times
momentarily (for <1 second) within 1 second. Nothing happens
Reset
mode performs a complete reset to factory defaults (except
Reset All IP Settings
mode is useful if you want to start over with configuration and
mode does.
TLI Pro 101 • Reference Material 28