Input Audio and Video
The two pairs of buttons on the right of the screen allow three
settings to be toggled On and Off.
— Enables 2CH PCM support on input EDID.
Input Audio
Input Audio is On by default.
HDCP Authorize
— When this setting is enabled,
HDCP-encrypted input signals pass to the output display.
HDCP Authorize is On by default.
— Press
Aspect Ratio
Fill
fills the entire screen. Press
Follow
the aspect ratio of the input signal.
— Press
Adjust Picture
dialog to adjust the input video picture. Press
those values.
Active Pixels
—
to
(default
Brightness
0
127
Contrast
—
0
to
127
(default
—
to
(default
Detail
0
127
(status only)
Active Pixels
Active Lines
(status only)
— Allows the current values to be saved as
Presets
a preset and opens the
Presets
below).
— Returns the picture values to their
Default all
default settings.
— Closes the dialog.
Exit
Presets
#
Input
Name
1
HDMI
Blu-ray
2
HDMI
Blu-ray 2
3
N/A
Preset 03
4
N/A
Preset 04
5
N/A
Preset 05
6
N/A
Preset 06
7
N/A
Preset 07
8
N/A
Preset 08
Figure 16.
Presets Dialog
— Highlight one of the presets and press
Save
and Detail settings to that preset.
— Highlight one of the presets and press
Recall
Brightness, Contrast and Detail with those saved by that preset.
— Highlight one of the presets and press
Rename
— Highlight one of the presets and press
Clear
preset.
to stretch the image so that it
for the image to maintain
to open a
Adjust Picture
Brightness
and
are read-only and cannot be edited.
Active Lines
)
64
64
)
)
64
dialog (see figure 16,
Save
Recall
Rename
Clear
to save the current Brightness, Contrast,
Save
Recall
Rename
to clear the values stored by that
Clear
TLI Pro 101 • On-screen Menus
Input Audio and Video
Input
On
Audio:
HDCP
On
Authorize:
Aspect
Fill
Follow
Ratio:
Adjust Picture
,
, or
to adjust
Contrast
Detail
Brightness
64
64
Contrast
64
Detail
Active Pixels
1280
Active Lines
720
Default
Presets
Exit
All
to replace the current settings for
to assign a new name to the preset.
Off
Off
20
Need help?
Do you have a question about the TouchLink TLI Pro 101 and is the answer not in the manual?
Questions and answers