Output - Speaker Settings; Gxd Amp Settings; On The Gxd Amplifier; On The Touchmix - QSC TouchMix-30 Pro User Manual

Output – Speaker Settings
Provides Gain setting recommendations for QSC
powered loudspeakers. Also provides a list of available
loudspeaker presets for various applications on both
powered and passive loudspeakers. Note that these
presets are not available for all QSC loudspeakers.
1. – Touch to select the QSC
Select Speaker
loudspeaker connected to the output.
2. – Select a preset for the connected
Preset
loudspeaker.
a. If you are using a powered loudspeaker make
sure the DSP is set to the default preset.
b. If you are using an E Series (passive)
loudspeaker make sure that any DSP in the
amplifier is set to the default preset. The QSC
GXD amplifier has a setting for TouchMix
mixers. Refer to the GXD topic.
3. – Adjust the Gain knob on
Set the Gain
your powered loudspeaker to the position
indicated by the illustration and the text below it.
4. When finished, touch the Done button.
NOTE: Subwoofer level may be adjusted to get the desired relative high/low balance.
When the speakers are adjusted as directed, signal to noise ratio is optimized and the output meters on the mixer reflect how much speaker
system headroom is available. Note that the LIMIT LED on the speakers is not a Clip indicator. It will be lit before the mixer's meters indicate
any overdrive. This is because the speakers' DSP is preventing dynamic peaks in the program from overdriving the amplifier and speakers.

GXD Amp Settings

Provides help in properly adjusting QSC GXD Amplifier when used with
the TouchMix.

On the GXD Amplifier

1. – If the amplifier's Gain screen is not displayed, press the Home
Home
button. If the Gain screen is displayed, skip to the next step.
2. Adjust the Gain A and Gain B knobs for 0.0 dB gain.
the next screen.
3. Adjust the Gain B/DSP Control knob to select Stereo DSP.
Moves to the next screen.
4. Adjust the Gain B/DSP Control knob to select Sensitivity.
to the next screen.
5. Adjust the Gain B/DSP Control knob to select TouchMix.
– Confirms selection.
Enter
6. – Returns to the Home screen.
Home

On the TouchMix

1. – Closes the GXD Amp Settings pop-up.
Done
1001108-01-F
Press Home
Aux Out 1 - 8
Aux 1
Inputs 1-8
Select QSC Speaker Model and Preset Name to display Gain Settings or Recall a Preset
3
2
Model Preset Name
K8.2 Dance
Floor Monitor
K10.2
K12.2 Live Bright
Live
Studio
Vocal Monitor
Done Recall Preset
Press Home
– Moves to
Enter
–
Enter
Navigate to "Home"
Gain A
– Moves
Enter
Gain B
Gain B
Gain B
Gain B
59
Touch an
Touch an
Output
Output Bank
Channel
K Series
K10.2
0dB
1
OFF
GAIN
Rotate Gain knob 5 detents (clicks) past zero.
Touch an
Touch an
Output
Output Bank
Channel
Aux Out 1 - 8
Aux 1 Amplifiers
Inputs 1-8
QSC GXD Amplifier Settings
HOME
HOME
0.0 dB
0.0 dB
ENTER
STEREO DSP
ENTER
SENSITIVITY
ENTER
TOUCHMIX
ENTER
HOME
Done
Touch
K Series
+10dB
Touch
Amplifiers