Configuration Can-Tool - Raven SBGuidance Onland Plough Installation Manual

4.1. Configuration CAN-Tool

Initialize the CAN tool. At Hardware, choose
manufacturer "Viper 4" in case of a Viper4
terminal and "SBG" in case of a GeoSTAR
terminal and press on Initialize.
After initializing the connection with the CAN
bus, a bus load must be displayed. Received
frames must be in increasing increments. The
bus load and received frames are displayed at
the bottom of the screen. If this is not the case,
check the cable connections.
Go to the tab page MyDevice (Figure 26) and at
Pre-selection select "Navigation Controller
(Implement)". Then press "Connect".
Go to the tab page MyPartners (Fout!
Verwijzingsbron niet gevonden.). At
Implement Controller press "Add". This will
open the setup screen for the Onland Plough
steering (Figure 28).
The steering controller is recognized if the
status is on Running, if an SW Version is
displayed and the correct type of STU is
detected. In addition, a sensor value should be
displayed and a yellow line should be visible in
the graphic display. The sensor value should
change when the steering controller is used
(Figure 28).
Check whether the Steering Controller is
recognized before you continue to set up
and calibrate the Onland Plough
steering.
Pag 28/39 I SBG-Onland-Plough-IM-EN-V1.3
SBGuidance Onland Plough I Version 1.3 I CAN
Figure 27 CANTool Mypartners Implement Controller
Figure 28 CANTool Onland Plough Steering
CAN