Table of Contents
Advertisement
SBGuidance Onland Plough I Version 1.3 I CAN
3.1.1. Lemken Juwel 8
The Lemken Juwel 8 adapter piece needs to be
mounted on that part of the plough frame that
holds the trailed wheel (Figure 21).
Place the adapter piece over the plough frame
and mark the positions of the mounting holes.
Remove the adapter frame and drill holes of
10,2 mm on the marked places on the plough
frame (four holes in total need to be drilled).
Afterwards cut M12 x 1.75 thread in those four
holes then mount the adapter frame again and
fixate it with four M12 x 30 bolts.
Mount the universal frame of the tilt mechanism
to the adapter piece in such a way that the
GPS-antenna moves on the outside of the
plough.
3.1.2. Kverneland LO/EO
The Kverneland LO/EO adapter piece needs to
be mounted on the end of the main frame of the
plough. This is also the place where the trailed
wheel is connected to the main frame (Figure
22).
The trailed wheel is mounted to the main frame
of the plough through eight M18 bolts. Replace
six of those eight bolts by 10.9 M18 x 60 bolts,
so that the adapter piece can be mounted in-
between.
Afterwards mount the universal of the tilt
mechanism to the adapter piece in such a way
that the GPS-antenna moves on the inside of
the frame.
Figure 21 Lemken Juwel 8
Figure 22 Kverneland LO/EO
SBG-Onland-Plough-IM-EN-V1.3 I Pag 25/39
Advertisement
Table of Contents
