Table of Contents
Advertisement
2. Installation basic components
It's advised to install the Onland Plough
steering kit in the order as listed below:
1. Mounting of the angle sensor.
2. Checking of the hydraulic manifold.
3. Mounting of the manifold and connecting
the hydraulic hoses.
4. Mounting of the Steering Controller.
5. Mounting of the proximity sensors.
6. Mounting of the GPS-antenna.
7. Placing and connecting of the cabling.
In this chapter of the installation manual the
assumption is made that the steering kit is
installed on an semi-mounted reversible plough
without the antenna tilt mechanism. For
installation instructions specific for the antenna
tilt mechanism see chapter 3 of this manual.
2.1. Mounting the angle sensor
The angle sensor measures the exact operating
width of the plough. Start with mounting the
angle sensor to the plough main frame.
In an Onland Plough steering kit an
angle sensor is delivered in an angle
sensor bracket (Figure 1) by standard.
Pag 12/39 I SBG-Onland-Plough-IM-EN-V1.3
SBGuidance Onland Plough I Version 1.3 I CAN
Figure 1 Angle sensor mounted in bracket
CAN
Advertisement
Table of Contents
