Configuration And Calibration; Configuration Can-Tool - Raven SBGuidance Side-Shift Installation Manual

Side-shift and drawbar steering

Table of Contents

3. Configuration and calibration

The following software and firmware versions

are required for the set-up, calibration and use

of the CAN Side-Shift controller:

 CAN-Tool 1.28 or more recent version.

 Side-Shift steering firmware STU_Side-

Shift_2.0.30 or more recent version

 SBGuidance 3.8.2 or more recent

version.

Check the download page on

www.sbg.nl

for the most recent software

and firmware versions.

View Configuration manual – CANbus

controllers for updating a steering

controller.

Startup the CAN tool. At Hardware, choose

manufacturer "Viper 4" in case of a Viper4

terminal and "SBG" in case of a GeoSTAR

terminal and press on Initialize.

After initializing the connection with the CAN

bus, a bus load must be displayed. Received

frames must be in increasing increments. The

bus load and received frames are displayed at

the bottom of the screen. If this is not the case,

check the lead connections.

Go to the tab page MyDevice (Figure 16) and at

Pre-selection select "Navigation Controller

(Implement)". Then press "Connect".

Go to the tab page MyPartners (Figure 17). At

Implement Controller press "Add". This will

Pag 20/30 I SBG-Side-Shift-IM-EN-V1.1

SBGuidance Side-Shift I Version 1.1 I CAN

Figure 16 CAN-Tool MyDevice Implement Controller

Figure 17 CANTool Mypartners Implement Controller

Table of Contents