Calibrating Angle Sensor - Raven SBGuidance Onland Plough Installation Manual

SBGuidance Onland Plough I Version 1.3 I CAN

4.3. Calibrating angle sensor

The angle sensor is placed to measure the
actual plough width. Calibrating the plough
width is needed so the angle sensor voltages
correspond correctly with the actual plough
width. Calibration can be done throughout the
tab page Wheel Sensor (Figure 32) and
Dimensions (Figure 33), but it's also possible to
determine them throughout SBGuidance
(Figure 34).
1. Place the plough in its most narrow
position and set the corresponding
sensor value by pressing the Narrowest
–button in the Wheel Sensor tab page
(Figure 32).
2. Place the plough in its widest position
and set the corresponding sensor value
by pressing the Widest –button in the
Wheel Sensor tab page.
Figure 31 Measuring plough width
Figure 32 CAN Tool tab page Wheel Sensor
SBG-Onland-Plough-IM-EN-V1.3 I Pag 31/39