Checking The Hydraulic Manifold - Raven SBGuidance Onland Plough Installation Manual

2.2. Checking the hydraulic manifold

The hydraulic implement manifold is suited for
use in both Load-Sense (L.S.) and Open Centre
(O.C.) hydraulic systems. Depending on the
type of installation a different type of selector
plug must be installed in the manifold (Table 2,
Figure 7).
Check the type of the selector plug (Figure 8)
before mounting the manifold.
Table 2 Selector plug manifold
Type of hydraulics
Load Sense
Open Centre
If the manifold is connected to the auxiliary
hydraulic connectors at the rear of the tractor,
the manifold must be configured in Open
Centre mode. The LS connector must be
capped.
When Open Centre is chosen, other
selector plugs need to be used in the
manifold when Load Sense is used!
The implement manifold is equipped with two
double controlled non-return valves by default
(Flucom CAP20/M). If the hydraulic system of
the plough is already equipped with such plugs,
the ones in the manifold need to be replaced
with blind plugs (Figure
The double controlled non-return valves
need to be replaced by blind plugs when
the hydraulic system of the plough is
already equipped with similar valves.
Pag 16/39 I SBG-Onland-Plough-IM-EN-V1.3
Selector plug
SBG10810
Blind plug without imprint
SBG10820
ELP30/D2
9).
SBGuidance Onland Plough I Version 1.3 I CAN
Figure 8 Selector plug
Figure 7 Selector plug. Left: L.S. Right O.C.
Figure 9 Above: blind plug Under: double controlled
non return valves (Flucom CAP20/M)
CAN