Configurator Setup - Raven SBGuidance Onland Plough Installation Manual

SBGuidance Onland Plough I Version 1.3 I CAN
3. Set both steering times (Cilinder In/Out
time) at 6 seconds to start with.
4. Determine the steering speed by tilting
the plough several times. Start with a Tilt
Speed of 25%. Decrease or increase the
steering speeds until the antenna pole
moves smoothly during the tilting
operation.
5. Decrease the steering times so that the
antenna still moves fully up or flat while
turning the plough. Set the Cilinder Out
Time and Cilinder In Time independent
from each other.
Important! Set the steering speed and
the steering times as accurate as
possible. The antenna pole needs to
move in a smooth manner to increase
the life span of the GPS-antenna.

4.6. Configurator setup

Add an machine profile to the loader screen
and name it appropriately.
Refer to the SBGuidance Auto CAN
setup and configuration manual for
further information on how to install
SBGuidance and use.
Open SBGuidance Configurator for this
machine profile. Under Machine settings in the
SBGuidance Configurator, setup and configure
the system and guidance type. Select system
type "CAN" and Guidance type "SBGuidance
Onland Plough".
No parameters are required on the tab page
Plough.
SBG-Onland-Plough-IM-EN-V1.3 I Pag 35/39