Table of Contents
Advertisement
2.6. Mounting of the GPS-Antenna
On a semi-mounted reversible plough the GPS-
antenna needs to be mounted near the trailed
wheel. Try to place the antenna as low as
possible and make sure the antenna stays free
of any contact during the flipping over process
of the plough. Keep in m the distance between
antenna and plough bodies. If the GPS-antenna
is mounted a little before the trailed wheel, the
distance to the plough bodies increases. This
results in a better satellite view for the antenna.
Figure 14 shows an example installation on an
semi-mounted reversible plough in transport
position. In this figure the antenna is mounted
ca. 2m before the trailed wheel. In Figure 15 the
same plough is shown, but now in ploughing
position.
On a mounted reversible plough the antenna
needs to be mounted on the antenna tilt
mechanism in order to rotate the antenna when
the plough is flipped over.
In chapter 3 the mounting and parts of
the antenna tilt mechanism are
described.
Pag 20/39 I SBG-Onland-Plough-IM-EN-V1.3
SBGuidance Onland Plough I Version 1.3 I CAN
Figure 14 GPS-antenna on semi-mounted reversible
plough in transport position
Figure 15 GPS-antenna mounted on semi-mounted
reversible plough in ploughing position
CAN
Advertisement
Table of Contents
