Table of Contents
Advertisement
3.2. Mounting of the 6/2 hydraulic valve
The cylinder present in the antenna tilt
mechanism is operated through the implement
manifold. To switch between operating the
antenna tilt cylinder and the width regulation
cylinder on the plough a 6/2 hydraulic valve
needs to be installed. The proximity sensors
mounted on the rear-mounted three-point
linkage of the plough determine which cylinder
needs to be operated: in ploughing position the
width regulation cylinder needs to be operated
and during the flipping over process the
antenna tilt cylinder needs to be operated.
Mount the 6/2 hydraulic valve somewhere
between the manifold and the width regulation
cylinder. When connecting the hydraulic hoses
try to open the existing hydraulic system where
there are already hydraulic fittings present.
Figure 24 shows an installation of the 6/2 valve
on top of the width regulation cylinder while
Figure 23 shows an installation between
existing hydraulic fittings.
Connect hydraulic hoses according to the
hydraulic schedule in Figure 25.
Pag 26/39 I SBG-Onland-Plough-IM-EN-V1.3
SBGuidance Onland Plough I Version 1.3 I CAN
Figure 24 6/2 hydraulic valve mounted on the width
regulation cylinder
Figure 23 6/2 valve mounted between the existing
hydraulic couplers
Figure 25 Hydraulic schematics tilt mechanism
CAN
Advertisement
Table of Contents
