Set-Up And Calibration; Set-Up With The Can Tool - Raven SBGuidance Disc Installation Manual

SBGuidance Disc I Rev. A I CAN

4. Set-up and calibration

The following software and firmware versions
are required for the set-up, calibration and use
of the CAN disc controller:
 CAN-Tool 2.0.38 or more recent version.
 Disc control firmware STU_DISK_3_0_38
or more recent version
 SBGuidance 4.2.115 or more recent
version.
Check the download page on
www.raveneurope.com
software and firmware versions.
To update the steering controller
firmware, see document:
CONFIGURATION MANUAL
FIRMWARE UPDATE
CANbus controllers
016-8000-031EN

4.1. Set-up with the CAN tool

Initialize the CAN tool. After initializing the
connection with the CAN bus, a bus load will be
displayed. The received frames must be
increasing. The bus load and received frames
are displayed at the bottom of the screen. If
not, check the wiring and connections.
Go to the tab page MyDevice and on Pre-
selection select "Navigation Controller
for the most recent
Figure 28 Navigation Controller (Implement)
SBG-Disc CAN-EN-Rev. A Page 37/50