Table of Contents
Advertisement
SBGuidance Onland Plough I Version 1.3 I CAN
2.1.1. Mounting of the angle sensor in
the bracket
Use the following description to mount the
angle sensor in the bracket (Figure 2):
1. The sensor consist of two parts, both
need to be mounted with M5 bolts. The
smallest piece (little disc) needs to be
mounted to the "arm"-bracket and the
biggest piece (sensor housing) needs
to be mounted to the "U"-shaped
bracket.
2. The sensor bracket consists of two
parts. Mount those parts in the following
order: M6 bolt, washer, "U"-shaped
bracket, fender washer, "arm"-bracket,
washer, split lock washer and nylon
insert lock nut.
3. Fasten the lock nut at its fullest then
loosen a little.
Before mounting, check if the sensor
disc can move freely in the sensor
housing when turning the sensor arm.
Make sure the little triangular markings
on both sensor disc and housing more or
less align when the sensor is in its centre
position.
Figure 2 overview of angle sensor bracket
SBG-Onland-Plough-IM-EN-V1.3 I Pag 13/39
Advertisement
Table of Contents
