Removing The Dasd Backplane Assembly - IBM TotalStorage 200 Service Manual

Removing the DASD backplane assembly

To remove the DASD backplane assembly:
1. Power OFF the appliance.
2. Disconnect all external cables from the appliance.
3. Pull out the hot-swap drives far enough to remove the DASD backplane
4. Remove the cover. See "Removing the cover (Model 200)" on page 51.
5. Disconnect cable.
6. Press the arrow on the tab 1 to release the backplane.
7. Carefully slide out the DASD backplane 2 to remove it.
1
Tab
2
DASD backplane
assembly.
Chapter 4. Adding and replacing components
89