IBM TotalStorage 200 Service Manual page 116

v If an administrator password is set, enter the administrator password at the
v Change the position of the password override switch as described in "Setting the
v Remove the battery and then install the battery.
Setting the password override switch:
Note: As shown in Figure 11 on page 49, switch 8 is the one at the top of the
To set the password override switch:
1. Review the information in "Before you begin" on page 43.
2. Switch OFF the appliance and peripheral devices and disconnect all external
3. Change the setting of the password override switch (switch 8 on switch block 1
4. Install the appliance cover (see "Removing the cover (Model 200)" on page 51)
Note: You can now start the Configuration/Setup utility program and change the
Administrator password
Select this to set an administrator password. The administrator password provides
access to all choices on the Configuration/Setup Utility main menu. You can set,
change, or delete both the administrator and power-on passwords, and allow a
power-on password to be changed by the user.
Attention:
overridden or removed. You must replace the system board.
Table 21 provides a summary of the password features.
Table 21. Power-on and administrator password features
Type of password
Power-on password
Administrator password
Administrator and power-on
password
100
Models 200 and 225 Service Guide
power-on prompt. Start the Configuration/Setup Utility program and change the
power-on password.
password override switch".
switch block (SW1).
cables and power cords; then, remove the cover. See "Removing the cover
(Model 200)" on page 51.
on the system board) to ON.
and connect all external cables and power cords.
power-on password. If you want the appliance to ask for a password when
you switch it on, set the password override switch back to the OFF position.
If an administrator password is set and then forgotten, it cannot be
Description
v Enter the password to complete the system startup.
v All choices are available on the Configuration/Setup Utility main menu.
v No password is required to start the system.
v Enter the password to access the Configuration/Setup Utility program.
v All choices are available on the Configuration/Setup Utility main menu.
v You can enter either password to complete the system startup.
v The administrator password provides access to all choices on the
Configuration/Setup Utility main menu. You can set, change, or delete both
the administrator and power-on passwords, and allow a power-on password
to be changed by the user.
v The power-on password provides access to a limited set of choices on the
Configuration/Setup Utility main menu. This limited access might include
changing or deleting the power-on password.