IBM TotalStorage 200 Service Manual page 46

Table 8. POST error codes (continued)
Error Meaning
Code/Symptom
163 Real-Time Clock error
164 Memory configuration
changed
175 Hardware error
176 Computer cover or cable
cover was removed without a
key being used
177, 178 Security hardware error
184 Power-on password
corrupted
185 Drive startup sequence
information corrupted
186 Security hardware control
logic failed
187 VPD serial number not set
188 Bad EEPROM CRC #2
189 An attempt was made to
access the appliance with
invalid passwords
201 Memory test error
30
Models 200 and 225 Service Guide
Suspected Part/Suggested Action
Suspected part:
1. Battery
2. System Board
Suggested action: Run Configuration/Setup
Suspected part:
1. DIMM
2. Processor/PCI Board
Suggested action: Run Configuration/Setup
Suspected part:
1. System Board
2. Processor/PCI Board
Suspected part:
1. System Board
2. C2 Security Switch
Suggested action: Run Configuration/Setup
Suspected part: System Board
Suggested action: Run Configuration/Setup
Suspected part: System Board
Suggested action: Run Configuration/Setup
Suspected part: System Board
Suggested action: Run Configuration/Setup
Suspected part: System Board
Suggested action: Run Configuration/Setup
Suspected part: System Board
Suggested action: Set serial number in Setup
Suspected part: System Board
Suggested action: Run Configuration/Setup
Suggested action: Run Configuration/Setup, enter the
administrator password
Suspected part:
1. DIMM
2. Processor/PCI Board
3. System Board
Suggested action: If the appliance does not have the latest
level of BIOS installed, update the BIOS to the latest level
and run the diagnostic program again.