Connecting A Serveraid-4H Controller Internal Channel Connector - IBM TotalStorage 200 Service Manual

8. Secure the controller by either tightening the expansion-slot screw on the top
of the controller or closing the latch, depending on your appliance.
9. Connect the internal SCSI cable to the controller. If you intend to attach
external devices only, go to step 13. Otherwise, continue with 10.
10. Connect one end of a 68-pin ANSI standard cable to the internal channel
connector on the ServeRAID controller.
Note: Refer to "ServeRAID-4L controller connector locations" on page 67 for
the channel connector locations.
Figure 28. Connecting a ServeRAID-4H controller internal channel connector
11. Make sure that the other end of the SCSI cable is attached to the SCSI
backplane.
12. If you have physical drives to install, install them now. See your appliance
documentation for drive installation instructions.
Note: The ServeRAID controllers use SCSI ID 7.
13. Install the appliance cover.
14. If you disconnected the cables and power cords in 2 on page 68, reconnect the
cables and cords. See your appliance documentation if you need detailed
instructions.
15. If you want to attach an external SCSI device to the ServeRAID controller,
continue with "Connecting external devices". Otherwise, go to "Updating BIOS
and firmware code" on page 70.
Connecting external devices
Note: The ServeRAID-4L does not support external connection. The ServeRAID-4H
supports external connection on Channels 2, 3, and 4.
Chapter 4. Adding and replacing components
69