Installing Adapters - IBM TotalStorage 200 Service Manual

10. Press Ctrl-Alt-Del to reboot the appliance.

Installing adapters

You can install up to three peripheral component interconnect (PCI) adapters in the
available expansion connectors, called slots, on the system board of the Model 200;
you can install up to four PCI adapters in the Model 225.
Your appliance comes with an integrated video controller, which is a component on
the system board. Both Network Attached Storage 200 contain a ServeRAID
adapter in PCI slot 3 (ServeRAID- 4L Ultra160 for Model 200 and ServeRAID-4H
Ultra160 for Model 225). For Model 200 only, PCI slot 1 contains 10/100 Ethernet
adapter.
3. Select Advanced functions.
4. Select Copy the configuration from drives to the controller.
5. Confirm the action by typing y. Wait until prompted to Press any key to
continue.
6. From the Advanced functions menu, select Configure BIOS settings.
7. Select Bypass read/verify operations and ensure that it says Yes. If it says
No, then press Enter to change the option to Yes.
8. Select Save configuration to the ServeRAID controller.
9. Select Exit; then, select Exit again. This will terminate the Mini-Configuration
program.
Chapter 4. Adding and replacing components
71