IBM TotalStorage 200 Service Manual page 39

Table 5. Diagnostic error codes (continued)
Error Code Meaning
035-XXX-099 No adapters were found
035-XXX-S99 Failed RAID test on PCI slot
S
035-XXX-SNN NN = SCSI ID of failing hard
disk
035-253-S99 RAID adapter initialization
failure; ServeRAID Adapter in
slot S is not configured
properly
075-XXX-000 Failed Power Supply test
089-XXX-001 Failed Microprocessor test
089-XXX-002 Failed Microprocessor test
165-XXX-000 Failed Service Processor test Suspected part:
180-XXX-000 Diagnostics LED failure
180-XXX-001 Failed information LED panel
test
180-XXX-002 Failed Diagnostics LED
Panel test
180-XXX-003 Failed System Board LED
test
Suspected Part/Suggested Actions
Suggested action: If the adapter is installed, re-check
connection.
Note: Check the System Error Log before replacing a part.
Suspected part:
1. Cable
2. SCSI Backplane
3. Adapter
Note: Check the System Error Log before replacing a part.
Suspected part: Hard Disk with SCSI ID NN on RAID adapter in
PCI slot S.
Suspected part:
1. Cable
2. SCSI Backplane
3. Adapter
Suggested action: Obtain the basic and extended configuration
status and refer to the ServeRAID Hardware Maintenance
Manual for more information.
Suspected part: Power Supply
Suspected part:
1. VRM 1
2. Microprocessor 1
Suspected part:
1. VRM 2
2. Microprocessor 2
1. System Board.
Note: Before replacing the System Board, ensure that
System Board jumper J-45 (the default) is not installed when
the error occurs.
2. Processor Board
3. Power Backplane
4. Hot-Swap Drive Backplane
Suspected part: Power Switch Assembly
Suggested action: Run the light-path diagnostics test for the
failing LED (see "Light-path diagnostics" on page 6).
Suspected part:
1. Information LED panel
2. Diagnostic LED panel
Suspected part:
1. Diagnostics LED Panel
2. Power Switch Assembly
Suspected part: System Board
Chapter 3. Symptom-to-part index
23