Starting The Configuration/Setup Utility Program - IBM TotalStorage 200 Service Manual

Starting the Configuration/Setup Utility program

To start the Configuration/Setup Utility program:
1. Switch on the appliance and watch the monitor screen.
2. When the message Press F1 for Configuration/Setup appears, press F1.
3. Follow the instructions that appear on the panel.
Important
Before you can start any diagnostic test, you must attach a keyboard and
monitor to the appliance. These items are not provided with the appliance and
must be obtained separately.
Note: If you have set both levels of passwords (user and administrator), you
must enter the administrator password to access the full
Configuration/Setup menu.
Chapter 5. Configuring the appliance
95