IBM TotalStorage 200 Service Manual page 48

Table 8. POST error codes (continued)
Error Meaning
Code/Symptom
962 Parallel port error
11XX System board serial port 1 or
2 error
0001200 Machine check architecture
error
0001295 ECC circuit check
2
1301 I C cable to front panel not
found
2
1302 I C cable from system board
to power on and reset
switches not found
2
1303 I C cable from system board
to power backplane not
found
2
1304 I C cable to diagnostic LED
board not found
1600 The Service Processor is not
functioning
32
Models 200 and 225 Service Guide
Suspected Part/Suggested Action
Suspected part: System Board
Suggested action:
1. Disconnect external cable on parallel port.
2. Run Configuration/Setup
Suggested action:
1. Disconnect external cable on serial port.
2. Run Configuration/Setup
3. System Board
Suspected part:
1. Processor
2. Optional Processor
3. Processor/PCI Board
Suspected part:
Processor/PCI Board
Suspected part:
1. Cable
2. Front Panel
3. Power Switch Assembly
4. System Board
Suspected part:
1. Cable
2. Power Switch Assembly
3. System Board
Suspected part:
1. Cable
2. Power Backplane
3. System Board
Suspected part:
1. Cable
2. Diagnostic LED Board
3. Power Switch Assembly
4. System Board
Suspected part:
1. System Board
2. Processor/PCI Board
Suggested action: Do the following before replacing:
1. Ensure that a jumper is not installed on J-51
2. Remove the ac power to the system, wait 20 seconds;
then, reconnect the ac power. Wait 30 seconds; then,
power-on the system.