IBM TotalStorage 200 Service Manual page 72

Model 200:
Hot-swap bays
Figure 17. Installing internal drive bays for the Model 200
Note: The SCSI IDs for the slim-high and half-high hot-swap hard drives are on a
Model 225:
SCSI ID 0
Figure 18. Installing internal drive bays for the Model 225
Installing and replacing hot-swap hard drives
Your appliance contains hardware that lets you continue to operate your system
while a hard drive is removed or installed. These hard drives are known as
hot-swappable hard drives. They are also referred to as hot-swap hard drives.
56
Models 200 and 225 Service Guide
Non-hot-swap
bay A
Non-hot-swap
bay B
Non-hot-swap
bay C
label on the bezel, immediately adjacent to the hot-swap hard drive bays.
Hot-swap bays
SCSI ID 1 SCSI ID 4
SCSI ID 3
SCSI ID 9
SCSI ID 5 Hard disk
activity light
Hard disk
status light
Non-hot-swap
bay D
SCSI ID 0
Hard disk
activity light
Hard disk
status light
SCSI ID 2
SCSI ID 3
SCSI ID 4
SCSI ID 8
SCSI ID 9
Non-hot-swap
bay A
Non-hot-swap
bay B
Non-hot-swap
bay C
Non-hot-swap
bay D