Serveraid-4L Controller - IBM TotalStorage 200 Service Manual

Network attached storage
Hide thumbs Also See for TotalStorage 200:
Table of Contents

Advertisement

Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
Note: For translations of this safety notice, refer to Safety Information.
ServeRAID-4L controller connector locations
The ServeRAID-4L controller has one independent SCSI channel connector:
Channel 1. This SCSI channels supports up to 15 physical devices.
Internal Channel 1
External Channel 1
Figure 26. ServeRAID-4L controller
You cannot attach any external devices to the ServeRAID-4L controller.
Note: The ServeRAID-4L controller uses the module (P/N 38L3386) containing a
lithium battery.
Statement 2
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has
a module containing a lithium battery, replace it only with the same module
type made by the same manufacturer. The battery contains lithium and can
explode if not properly used, handled, or disposed of.
67
Chapter 4. Adding and replacing components

Advertisement

Table of Contents
loading

This manual is also suitable for:

Totalstorage 225

Table of Contents