Connecting External Options; Installation Procedure; Input/Output Connector Locations; Replacing The Model 225 Bezel - IBM TotalStorage 200 Service Manual

Model 225:
Figure 39. Replacing the Model 225 bezel
To replace the bezel:
1. Place the tabs on the left side of the bezel in the slots at the left front of the
2. Press the right end of the bezel toward the appliance until the bezel clicks into

Connecting external options

This section shows you the location of the parts to which you can connect any
external devices.

Installation procedure

To attach an external device:
1. Read "Before you begin" on page 43 and the documentation that comes with
2. Switch off the appliance and all attached devices.
3. Follow the instructions that come with the option to prepare it for installation and

Input/output connector locations

The following illustration shows the input/output connectors (ports) and the
expansion slots on the rear of the appliance. For pin assignments and other details
about these connectors, see "Input/output ports" on page 84.
appliance.
place.
your options.
to connect it to the appliance.
Bezel
Chapter 4. Adding and replacing components
83