Advertisement
Quick Links
Advertisement
Related Manuals for IBM TotalStorage NAS 100
Summary of Contents for IBM TotalStorage NAS 100
- Page 1 IBM TotalStorage NAS 100 Rack Installation Instructions...
- Page 3 IBM TotalStorage NAS 100 Rack Installation Instructions...
- Page 4 First Edition (August 2002) © Copyright International Business Machines Corporation 2002. All rights reserved. US Government Users Restricted Rights – Use, duplication or disclosure restricted by GSA ADP Schedule Contract with IBM Corp.
- Page 5 Assorted hardware, including cage nuts, clip nuts, screws, nuts, and washers v One Rack Installation Instructions (this manual) Items that you provide: v One Phillips #2 screwdriver v One flat-blade screwdriver (if you are using cage nuts) v One nutdriver or pair of pliers © Copyright IBM Corp. 2002...
-
Page 6: Attaching The Brackets
Attaching the brackets The following procedure explains how to attach the brackets to the telescopic slide rails. 1. Extend the inner server slide rail as far as it will go. 2. Pull the white spring tab on the server slide rail towards its open end and remove the server slide rail. - Page 7 Insert an M4 screw through the bracket and in the alignment screw hole, fasten a washer and an M4 nut to it, and firmly tighten them. Repeat this step with three more screws in the remaining holes. 4. Extend the slide rails fully. ™ IBM TotalStorage NAS 100 Rack Installation Instructions...
- Page 8 5. Loosely attach the next bracket to the back end of the telescopic slide rail with four more M4 screws, washers, and nuts, as shown in the following figure. Telescopic slide rail Bracket Note: Do not completely tighten these screws until you install the slide rail into the rack.
- Page 9 Note: Make sure that you insert each of the bottom nuts at the same height on the rack so that the installed NAS 100 will be level. Cage or clip (shown) nut Front bracket Back bracket Left/right front mounting template Left/right back mounting template ™ IBM TotalStorage NAS 100 Rack Installation Instructions...
- Page 10 3. Secure the front end of the slide rail to the front of the rack with three M6 screws. 4. Secure the back end of the slide rail to the back of the rack with two M6 screws. 5. Tighten the rear bracket M4 screws of the telescopic slide rail. 6.
- Page 11 4. Secure the first mounting ear to the side of the NAS 100 with two blue-coated screws. 5. Repeat this procedure with the other mounting ear. Mounting ear Spring tab Server slide rail ™ IBM TotalStorage NAS 100 Rack Installation Instructions...
- Page 12 4. Push the server firmly into the rack to secure it. 5. Use the mounting ear thumbscrews to attach the NAS 100 to the rack. 6. Refer to the IBM TotalStorage NAS 100 Hardware Installation and Service Guide, GA27-4311 to complete the installation of the NAS 100.
- Page 13 NAS 100 out of the rack. 3. If you are replacing the NAS 100, remove the server slide rails and put them in a safe place. You will reinstall them on the new, rack-mounted NAS 100. ™ IBM TotalStorage NAS 100 Rack Installation Instructions...
- Page 14 NAS 100 Rack Installation Instructions...
- Page 15 Java and all Java-based trademarks and logos are trademarks or registered trademarks of Sun Microsystems, Inc. in the United States, other countries, or both. Other company, product, and service names may be trademarks or service marks of others. © Copyright IBM Corp. 2002...
- Page 16 NAS 100 Rack Installation Instructions...
- Page 18 Part Number: 55P4045 Printed in Taiwan (1P) P/N: 55P4045...