IBM TotalStorage 200 Service Manual page 123

3
A
Use the pins on the slide rail to align the
A
slide rail to the rack. Use the M6 screws to
bolt the slide rail to the rack (left front of rack
shown here). Repeat this step for the other
slide rail.
5
B
A
C
Caution: To avoid injury, do not place your
fingers around the rack-support wheels when
appliance
lowering the onto the rails.
Fully extend the slide rails out of the rack. Lift
appliance
the above the rails; then, rest the
rack-support wheels located on the rear of the
A
appliance
on the slide rails. Lower the front of
appliance
the onto the slide rails.
Note: Be sure the bracket notches
appliance
front of the fit securely on the tabs
located on the front of the slide rails.
4
Use the M6 screws to attach the hinge bracket
to the rear of the rack. Then, use the hinge
A
pin to attach the cable-management
B
assembly to the slide rail. (Right rear of rack
shown here).
6
A
Use the M4 screws to secure the appliance to
the rails. Unscrew the rack-support wheels
and store them in a safe place.
on the
B
C
Appendix A. Rack Installation Instructions
B
A
A
107